Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Preparation tool:

Circuit tester

1. Connect three dry cell batteries (1.5 V) in series.

NOTE:

Use new dry-cell batteries.

Using circuit tester, check that the initial voltage of a single dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries in series is between 4.8 V and 5.2 V.

For power supply, 5 V DC voltage source can also be used.

2. Connect the cell battery positive terminal to the connector terminal No. 3, and the cell battery negative terminal to the connector terminal No. 1.

3. With voltage applied, measure the voltage between connector terminals when the sensor link is moved slowly up and down.

Terminal No.

Inspection conditions

Standard

2 (+) — 1 (−)

Move the link within the operation range.

0.5 — 4.1 V

4. Replace the sensor assembly - headlight beam leveler if the inspection result is not within the standard value.

Removal
CAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicl ...

Installation
1. Install the sensor assembly - headlight beam leveler.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the rear wheels.Tightening torque:120 N·m (12.2 kgf-m, 88.5 ft-lb)3. Lo ...

Other materials:

Procedure
1. Activation of malfunction indicator light Malfunction Indicator Light > ACTIVATION OF MALFUNCTION INDICATOR LIGHT↓2. Malfunction indicator light does not come on Malfunction Indicator Light > MALFUNCTION INDICATOR LIGHT DOES NOT COME ON↓3. Malfunction indicator light does not go off ...

© 2017-2024 Copyright www.sulegacy.com