Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Measure the resistance between connector terminals. Terminal No. | Inspection conditions | Standard | 1 — 3 | Switch OFF | 1 M- or more | Switch ON | Less than 1 - | 2 — 3 | Switch door | Less than 1 - |
2. Apply battery voltage between the connector terminals to check the lighting condition of the light. Terminal No. | Inspection conditions | Specification | 3 (+) — 1 (−) 3 (+) — 2 (−) | Switch OFF | Light OFF | Switch ON | Light ON | Switch door | Light ON |
3. Replace the light assembly - room if the inspection result is not within the standard value. |
NOTE:Do not remove the room light if removing the bulb only.1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the light assembly - room.(1) Remove the clips, and then remove the ho ...
1. Install the lens and bulb.CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.2. Install the light assembly - room.3. Connect the ground terminal to ba ...
Other materials:
Dtc p2012 tgv control circuit low bank 2
DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE TYPE FB (WITHOUT PUSH BUTTON ST ...