Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.

Inspection conditions

Standard

5 — 6

Switch OFF

1 M- or more

Switch ON

Approx. 18 -

2. Replace the overhead console or stereo camera cover if the inspection result is not within the standard value.

Removal
NOTE:• The spot map light is a single unit with the overhead console or stereo camera cover. Replace the overhead console or stereo camera cover if faulty.• Do not remove the spot map ligh ...

Installation
1. Install the spot map light cover and bulb.CAUTION:Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.2. Install the overhead console. (Models without EyeSight ...

Other materials:

Dtc p0101 mass or volume air flow sensor "a" circuit range/performance
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Improper idling• Engine stalls.• Poor driving performanceCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspecti ...

© 2017-2024 Copyright www.sulegacy.com