Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lighting system / Srf off switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 4	OFF	1 M- or more
1 — 4	ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) — 3 (−)	Apply battery voltage.	Light ON

3. Replace the SRF OFF switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Release the claws and remove the SRF O ...

Installation

1. Install the SRF OFF switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc p060a internal control module monitoring processor performance
NOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCESSOR1. OUTLINE OF DIAGNOSISJudge as NG when the monitoring IC operation is abnormal.(1) Monitoring IC Disable (motor continuity cut demand) diagnosis(2) Mon ...