1. Ball bearing Replace the ball bearing in following cases. • In case of broken or rusty ball bearings • In case of worn or damaged ball bearings • When the ball bearings fail to turn smoothly or emit noise in rotation after transmission gear oil has been applied. 2. Transfer drive gear If the tooth face of transfer drive gear and the shaft are excessively broken or damaged, replace the transfer drive gear. 3. Measure the clearance between snap ring and inner race of ball bearing with a thickness gauge. Clearance: 0.01 — 0.15 mm (0.0004 — 0.0059 in) If the measurement is not within specification, select a suitable snap ring and replace it.
|
Installation
CAUTION:• For parts which are not reusable, always use new parts.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.• During the installation, make sure that the marking of ABS wheel speed sensor harness ...