Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Memory height switch / Inspection

1. Measure the resistance between switch terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 4	Switch OFF	1 M- or more
1 — 4	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) — 3 (−)	Apply battery voltage.	Light ON

3. Replace the memory height switch, if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Release the claws and remove the memor ...

Installation

1. Install the memory height switch.2. Install the cover assembly - instrument panel LWR driver.3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Caution
• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassembled parts in order and protect them from dust and dirt.• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, insta ...