Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate inner switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 2	Switch OFF	1 M- or more
1 — 2	Switch ON	Less than 1 -

2. Replace the power rear gate inner switch, if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the power rear gate inner switch.(1) Release the claws and pull out the power rear gate inner switch rearward.NOTE:Insert a flat t ...

Installation

1. Install the power rear gate inner switch.2. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Dtc p0223 throttle/pedal position sensor/switch "b" circuit high
DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Improper idling• Poor driving performance• Engine stalls.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PRO ...