Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Power rear gate system / Power rear gate rod / Inspection

Check the ball housing and ball stud (bracket rod - power rear gate) of the rod - power rear gate for excessive play, wear or bent. Replace the rod - power rear gate if defective.

Removal

1. Hold the rear gate to the fully open position.2. Disconnect the ground terminal from battery sensor. NOTE3. Release the claws and then remove the cap - rear quarter pillar UPR LH.4. Remove the rod ...

Installation

1. Install the new stop ring to the rod - power rear gate.CAUTION:• Do not reuse the stop ring.• Align the stop ring to the ball housing groove, and attach the ring by gradually applying f ...

Other materials:

Dtc p2757 torque converter clutch pressure control solenoid control circuit performance/stuck off
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:No lock-up occurs.1. ENGINE TYPE FBWIRING DIAGRAM:CVT control system CVT Control System > WIRING DIAGRAMSTEPCHECKYESNO1.CHECK DTC.Read the DTC using Subaru Select Monitor.Besides DTC P2757, is any ...