Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Push button ignition switch / Inspection

1. Check the continuity between the connectors.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Specification
4 (COM) — 5 (GND)	Always	Continuity exists
7 (SSW1) — 5 (GND)	Push button ignition switch released > pressed	Continuity exists
2 (SSW2) — 5 (GND)	Push button ignition switch released > pressed	Continuity exists

2. Check the push button ignition switch operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Specification
11 (SWIL) — 5 (GND)	Connect battery to the terminals	Goes off > Red switch illumination light
12 (INDS) — 5 (GND)		Turns off > Switch indicator lights in green
13 (INDW) — 5 (GND)		Turns off > Switch indicator lights in orange

3. Replace the push button ignition switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the visor assembly - lower.(1) ...

Installation

1. Install the push button ignition switch to the visor assembly - lower.2. Install the visor assembly - lower.3. Install the cover assembly - instrument panel LWR driver.4. Connect the ground termina ...

Other materials:

Battery drainage prevention function
If a door or the rear gate (Outback) is not completely closed, the interior lights will remain illuminated as a result. However, several lights are automatically turned off by the battery drainage prevention function to prevent the battery from going dead. The following interior lights are af ...