Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Security and locks / Trunk lid latch and actuator assembly / Inspection

1. LATCH

Check if the latch operates normally.

If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the lock assembly - trunk lid.

2. ACTUATOR

1. Check door lock operation

Check the door lock operation when battery voltage is applied between the connectors.

Terminal No.	Inspection conditions	Standard
1 (+) — 2 (−)	Connect battery to the terminals	LOCK > UNLOCK

2. Check switch

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
2 — 3	LOCK	1 M- or more
2 — 3	UNLOCK	Less than 1 -

3. If it does not operate normally, replace the lock assembly - trunk lid.

Removal

1. Open the trunk lid COMPL.2. Disconnect the ground terminal from battery sensor. NOTE3. Remove the trim panel - trunk lid. Trunk Room Trim > REMOVAL4. Remove the lock assembly - trunk lid.(1) Disc ...

Installation

1. Install the lock assembly - trunk lid.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Connect the ground terminal to battery sensor. NOTE3. Install the trim panel - trunk lid. Trunk Roo ...

Other materials:

General diagnostic table inspection
SymptomsPossible causeCorrective actionWheel is out of balance.Improperly inflated tireAdjust the tire pressure.Uneven wearCheck the tire referring to “Abnormal tire wear” in this table, carry out the procedure and replace the tire.Front wheel alignmentCheck or adjust the front wheel ali ...