Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Vehicle dynamics control (vdc) / Hill hold switch / Inspection

1. Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Terminal No.	Inspection conditions	Standard
1 — 4	Switch OFF	1 M- or more
1 — 4	Switch ON	Less than 1 -

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.

Terminal No.	Inspection conditions	Specification
2 (+) — 3 (−)	Apply battery voltage.	Light ON

3. Replace the hill hold switch if the inspection result is not within the standard value.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - front. Console Box > REMOVAL3. Release the claws and remove the hill hold switch. ...

Installation

1. Install the hill hold switch.2. Install the cover assembly - front. Console Box > INSTALLATION3. Connect the ground terminal to battery sensor. NOTE ...

Other materials:

Adjustment
1. PROCEDURE TO ADJUST THE SUBARU SUPER COOLANT CONCENTRATIONCAUTION:Use the SUBARU Super Coolant with a 50 — 60% concentration in order to obtain maximum anti-freeze and anti-rust performance.To adjust the concentration of SUBARU Super Coolant according to temperature, find the proper SUBARU Supe ...