1. Measure the resistance between connector terminals. Preparation tool: Circuit tester
2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
3. Replace the VDC OFF switch if the inspection result is not within the standard value. |
Adjustment
Adjust the clearance around the panel assembly - rear door as follows.PartStandardAPanel assembly - front door to Panel assembly - rear door4.4+1.5, −1.0 mm (0.17+0.06, −0.04 in)BFront door sash to Rear door sash4.2±1.25 mm (0.17±0.05 in)CPanel side outer to Rear door sash5.2+1.5, &min ...