Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Emission control (aux. Emission control devices)(h6do) / Purge control solenoid valve / Inspection

1. PURGE CONTROL SOLENOID VALVE

1. Check that the purge control solenoid valve has no deformation, cracks or other damages.

2. Measure the resistance between the purge control solenoid valve terminals.

Terminal No.	Standard
1 and 2	24±3 - (20°C (68°F))

3. Check that air does not come out from (B) when air is blown into (A).

4. Connect the battery positive terminal to the terminal No. 1 and the battery negative terminal to the terminal No. 2. Check that air is discharged from (B), when supplying air to (A).

2. OTHER INSPECTIONS

Check the vacuum hose for cracks, damage or looseness.

Removal

1. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the front of collector cover at two positions (B) while moving it forward.2. ...

Installation

1. Install the purge control solenoid valve, and connect the connector and vacuum hose to the purge control solenoid valve.NOTE:Connect the vacuum hose as shown in the figure.(a)To intake manifold(b)T ...

Other materials:

Inspection
1. Check the thickness of the pad - disc brake rear.NOTE:• Always replace the pads of both wheels and both sides as a set.• Replace pad clips if they are twisted or worn.• Replace the pad if there is oil or grease on it.• Wear indicators are installed on the pad - disc brake ...