1. WASHER PUMP Apply battery voltage to the connector terminal of the motor pump assembly - washer, and make sure that the motor operates. 2. WASHER FLUID LEVEL SENSOR 1. Check the connection status of washer fluid level sensor connector. 2. Does the low washer fluid warning light illuminate after draining the washer fluid- And does the low washer fluid warning light go off after refilling the washer fluid- • Yes > Normal operation. • No > Perform step 3. 3. Using a tester, measure the voltage of the washer fluid level sensor connector. (1) Is the voltage approx. 8.5 V or more- • Yes > Perform step 4. • No > Check harness, meter and integrated unit, and replace if necessary. 4. Does the meter indicator illuminate if you short the washer fluid level sensor connector- • Yes > Perform step 5. • No > Check meter and integrated unit, and replace if necessary. 5. Using a tester, measure the resistance of the washer fluid level sensor. (1) Turn over the mud guard. (2) Measure the resistance of the washer fluid level sensor.
(3) Is the resistance within the standard- • Yes > Normal operation. • No > Replace the washer level sensor. |
Dtc c1531 bls off stuck
DTC DETECTING CONDITION:A fault is detected if stop light switch signal is OFF for a predetermined time or more with the pressure signal of the pressure sensor high.TROUBLE SYMPTOM:• VDC does not operate.• Hill hold does not function.• EyeSight does not operate. (Models with EyeSig ...