Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Wiper and washer systems / Wiper blade / Inspection

1. Check and clean the rubber assembly - wiper.

CAUTION:

• Do not use organic solvent-based cleaner when cleaning rubber parts in order to avoid rubber part deterioration.

• Do not continue to use damaged blade rubber.

The windshield glass may be damaged. If the wiping performance decreases or any distinct streak is found, replace it as soon as possible.

• Clean rubber parts using a soft cloth or paper towel dampened with windshield washer fluid or mild synthetic detergent.

• Use Subaru genuine part only for wiper blade body and blade rubber.

For model with EyeSight, using the part other than genuine part will affect the recognition of the stereo camera, which may cause the function not to operate correctly.

Replace the rubber assembly - wiper if rubber part hardening, deformation or damage is found.

2. Operate the washer system to check if a chattering sound or insufficient wiping occurs.

3. If a chattering sound or insufficient wiping occurs, perform the following procedures.

(1) Make sure that the blade assembly - wiper is not deformed and the movable part moves smoothly.

(2) Remove oil film and dirt from the glass.

CAUTION:

• When powder-type glass cleaner is used, use after having been dissolved in water sufficiently. If it is used in less water, the glass surface may be damaged.

• Clean the glass surface using a soft cloth or sponge with glass cleaner.

(3) Operate the windshield wiper again. If a chattering sound or insufficient wiping occurs, perform the procedures again.

4. If defective is not improved after performing step 1) to step 3), replace the rubber assembly - wiper with a new part.

Installation

Install each part in the reverse order of removal.CAUTION:Make sure the locking clip is secured.NOTE:Since the arm assembly - windshield wiper LH and RH can interfere with each other, install the pass ...

Disassembly

1. FRONTPull side (A) of the wiper rubber stopper, and remove the rubber assembly - windshield wiper from the blade assembly - windshield wiper.2. REARSlightly pull the top of the rubber assembly - re ...

Other materials:

Basic operation
By operating " " or " " of the control switch, the screens and selection items can be switched. When the " /SET" switch is pulled toward you, the item can be selected and set. If there are some useful messages, such as vehicle information, warning information, etc., they will interrupt t ...