Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Front regulator and motor assembly / Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.

• LH side

Terminal No.	Inspection conditions	Standard
6 (+) — 3 (−)	Apply battery voltage between terminals.	Increase
3 (+) — 6 (−)	Apply battery voltage between terminals.	Decrease

• RH side

Terminal No.	Inspection conditions	Standard
1 (+) — 4 (−)	Apply battery voltage between terminals.	Increase
4 (+) — 1 (−)	Apply battery voltage between terminals.	Decrease

2. If it does not operate properly as a result of inspection, replace the regulator and motor assembly - front.

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOVAL3. Remove the sealing ...

Installation

1. Install the regulator and motor assembly - front.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the glass assembly - front door. Front Door Glass > INSTALLATION3. Install the se ...

Other materials:

Preparation tool
1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — (Newly adopted tool)SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.2. GENERAL TO ...