Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Rear regulator and motor assembly / Inspection

1. Check the motor operation when battery voltage is applied between the connector terminals.

• LH side

Terminal No.	Inspection conditions	Standard
4 (+) — 1(−)	Apply battery voltage between terminals.	Increase
1 (+) — 4(−)	Apply battery voltage between terminals.	Decrease

• RH side

Terminal No.	Inspection conditions	Standard
3 (+) — 6(−)	Apply battery voltage between terminals.	Increase
6 (+) — 3(−)	Apply battery voltage between terminals.	Decrease

2. If it does not operate properly as a result of inspection, replace the regulator and motor assembly - rear.

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the trim panel - rear door. Door Trim > REMOVAL3. Remove the sealing cover - rear door.4. Remove the glass assembly - rear door. ...

Installation

1. Install the regulator and motor assembly rear.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-lb)2. Install the glass assembly - rear door. Rear Door Glass > INSTALLATION3. Install the sealing ...

Other materials:

Operation
1. On «Main Menu» display, select «Each System Check».On «System Selection Menu» display, select «Engine Control System».2. Drive vehicle at 40 km/h (25 MPH) or more and set the cruise control.CAUTION:• When performing diagnosis, observe the legal speed limit on the road.• The ca ...