Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Glass windows mirrors / Remote control mirror switch / Inspection

1. Check the resistance between connector terminals.

Preparation tool:

Circuit tester

• Changeover switch RH

Terminal No.	Inspection conditions	Standard
—	OFF	1 M- or more
1 — 12 9 — 7	UP	Less than 1 -
1 — 9 12 — 7	DOWN	Less than 1 -
1 — 11 12 — 7	LEFT	Less than 1 -
1 — 12 11 — 7	RIGHT	Less than 1 -

• Changeover switch LH

Terminal No.	Inspection conditions	Standard
—	OFF	1 M- or more
1 — 14 8 — 7	UP	Less than 1 -
1 — 8 14 — 7	DOWN	Less than 1 -
1 — 10 14 — 7	LEFT	Less than 1 -
1 — 14 10 — 7	RIGHT	Less than 1 -

2. If the inspection result is not within the standard, replace the switch - door mirror.

Removal

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOVAL3. Remove the panel - ...

Installation

1. Install the switch - door mirror to the panel - power window main switch.2. Install the panel - power window main switch to the trim panel - front door.3. Install the trim panel - front door. Door ...

Other materials:

Time lag test inspection
NOTE:When the select lever is shifted while the engine is idling, there will be a certain time elapse or lag before shock is felt. This symptom helps to check the condition of forward clutch and reverse brake.• Perform the test at normal operation CVTF temperature of 60 — 80°C (140 � ...