Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

1. CHECK FUSE

1. Remove the fuse and inspect visually.

2. If the fuse is blown out, replace the fuse.

2. CHECK RELAY

1. Measure the resistance between relay terminals.

Terminal No.

Inspection conditions

Standard

Circuit

1 — 2

Always

1 M- or more

1 — 2

Apply battery voltage between terminals 4 and 3.

Less than 1 -

2. Replace the relay if the inspection result is not within the standard value.

Location
Main fuse box (M/B)Horn relay(A)Fuse 7.5 A (horn assembly - Hi)(B)Fuse 7.5 A (horn assembly - Lo)(C)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit ...

Ignition(h4do)
...

Other materials:

Dtc b2240 can communication (audio) stuck
DTC DETECTING CONDITION:Detected when the resistor is stuck during the CAN bus communication process.TROUBLE SYMPTOM:Screen display does not link with combination meter or vehicle.STEPCHECKYESNO1.CHECK DTC.Inspect LAN system. Basic Diagnostic Procedure > PROCEDUREIs there any fault-Perform the diag ...

© 2017-2024 Copyright www.sulegacy.com