Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

1. COMMUNICATION FOR INITIALIZING IMPOSSIBLE

When communication with the radar sensor is impossible

DETECTING CONDITION:

Defective harness connector

Power supply circuit malfunction

Defective radar sensor

Defective CAN communication circuit

Defective Subaru Select Monitor

TROUBLE SYMPTOM:

Communication is impossible between radar sensor and Subaru Select Monitor.

WIRING DIAGRAM:

NOTE:

For the coupling connector, refer to “WIRING SYSTEM”.

BSD/RCTA system Blind Spot Detection/Rear Cross Traffic Alert > WIRING DIAGRAM

STEPCHECKYESNO

1.CHECK FUSE.

1) Turn the ignition switch to OFF.

2) Check the fuse for radar sensor LH. Relay and Fuse

Is it normal-

Subaru Select Monitor > INSPECTION

Replace the fuse. If the replaced fuse has blown out immediately, repair the short circuit to ground in harness between fuse and radar sensor LH.

2.CHECK HARNESS (OPEN CIRCUIT).

1) Disconnect the radar sensor LH connector.

2) Turn the ignition switch to ON.

3) Using a tester, measure the voltage between radar sensor LH connector (harness side) and chassis ground.

Connector & terminal

(R25) No. 5 (+) — Chassis ground (−):

Is the voltage 10 V or more-

Subaru Select Monitor > INSPECTION

Repair the open circuit of harness between fuse and radar sensor LH connector.

3.CHECK HARNESS (OPEN CIRCUIT).

1) Turn the ignition switch to OFF.

2) Using a tester, measure the resistance between radar sensor LH connector (harness side) and chassis ground.

Connector & terminal

(R25) No. 10 — Chassis ground:

Is the resistance less than 1 --

Subaru Select Monitor > INSPECTION

Repair the open circuit in harness between radar sensor and chassis ground.

4.CHECK LAN SYSTEM.

1) Connect the radar sensor LH connector.

2) Inspect LAN system. Basic Diagnostic Procedure

Is it normal-

Subaru Select Monitor > INSPECTION

Perform the inspection according to the diagnosis for LAN system.

5.CHECK RADAR SENSOR.

Communicate with the radar sensor.

Is communication possible-

The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Replace the radar sensor LH. Radar Sensor

Operation
• For operation procedures, refer to “Application help”.• When the radar sensor cannot communicate with Subaru Select Monitor, perform “COMMUNICATION FOR INITIALIZING IMP ...

System operation check mode
...

Other materials:

Installation
1. Support the fuel tank with a transmission jack, set the fuel tank and the fuel tank band in place, and temporarily tighten the bolts of the fuel tank band.WARNING:A helper is required to perform this work.2. Correctly insert the fuel filler hose to the spool, and then install the clamp as shown.T ...

© 2017-2024 Copyright www.sulegacy.com