It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded. 1. INSPECTION MODE 1
Diagnostic procedure: 1. Perform the Clear Memory Mode. Clear Memory Mode 2. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) 3. Turn the ignition switch ON > OFF, and wait for 45 seconds or more. 4. Turn the ignition switch OFF > ON, and wait for 5 seconds or more. 5. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. 2. INSPECTION MODE 2
Diagnostic procedure: 1. Perform the Clear Memory Mode. Clear Memory Mode 2. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) 3. Initialize the power seat system. Power Seat System > ADJUSTMENT 4. Turn the ignition switch ON > OFF, and wait for 45 seconds or more. 5. Turn the ignition switch OFF > ON, and wait for 5 seconds or more. 6. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. 3. INSPECTION MODE 3
Diagnostic procedure: 1. Perform the Clear Memory Mode. Clear Memory Mode 2. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) 3. Operate the power seat switch. (Any of slide/reclining/lifter/tilt) 4. Turn the ignition switch ON > OFF, and wait for 45 seconds or more. 5. Turn the ignition switch OFF > ON, and wait for 5 seconds or more. 6. Read the DTC and check that the DTC is not displayed. Read Diagnostic Trouble Code (DTC) NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. |
Inspection
1. Check that the manifold absolute pressure sensor has no deformation, cracks or other damages.2. Connect dry-cell battery positive terminal to terminal No. 3 and dry-cell battery ground terminal to terminal No. 2, circuit tester ground terminal to terminal No. 2 and the circuit tester positive ter ...