It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded. 1. INSPECTION MODE 1
Inspection steps: 1. Perform the Clear Memory Mode. Clear Memory Mode 2. Read the DTC and check that the DTC is not displayed. Diagnostic Code(s) Display NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. After solving the DTC, repeat from step 1). 3. Turn the ignition switch to OFF. 4. Turn the ignition switch to ON, and wait for 5 seconds or more. 5. Read the DTC and check that the DTC is not displayed. NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. 2. INSPECTION MODE 2
Inspection steps: 1. Perform the Clear Memory Mode. Clear Memory Mode 2. Read the DTC and check that the DTC is not displayed. Diagnostic Code(s) Display NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. After solving the DTC, repeat from step 1). 3. Turn the ignition switch to OFF. 4. Close all doors. (The vehicle enters CAN sleep state.) 5. Wait for approx. 1 minute. After the indicator goes off, wait for another 1 minute. (DCM standby mode) 6. Turn the ignition switch to ON, and wait for 5 seconds or more. 7. Read the DTC and check that the DTC is not displayed. NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis according to DTC. |
Disassembly
1. Place alignment marks on the shaft and outer race.2. Remove the PTJ boot band and boot.CAUTION:Be careful not to damage the boot.3. Remove the snap ring from PTJ outer race.4. Remove the PTJ outer race from shaft assembly.5. Wipe off grease.CAUTION:The grease is a special type of grease. Do not m ...