1. Replace the seal sub assembly for the master cylinder assembly with a new part. CAUTION: Be careful not to install the seal sub assembly in the wrong location.
2. Install the master cylinder assembly. Tightening torque: 13 N·m (1.3 kgf-m, 9.6 ft-lb) 3. Turn and tighten the flare nut (b) by hand while pressing the brake pipe (a) toward the master cylinder assembly side. CAUTION: Be careful not to make scratches or other damage to the inside surface of the brake pipe flare. Tightening torque: 19 N·m (1.9 kgf-m, 14.0 ft-lb) 4. Bleed air from the brake system and clutch system (MT model). Air Bleeding > PROCEDURE 5. Connect the ground terminal to battery sensor. NOTE |
Disassembly
1. TRANSFER CASE1. Remove the interlock plate.NOTE:Do not remove the precoat bolt (B) if the parts are assembled as a transmission assembly.(A)Interlock plate(B)Precoat bolt2. Remove the shift link assembly. Shift Link Assembly > REMOVAL2. EXTENSION CASE1. Remove the transfer drive gear assembly. ...