NOTE: Before installation, remove mud and foreign matter from the disc brake assembly. 1. Install the pad - disc brake rear. 2. Install the caliper body assembly. Tightening torque: Caliper bolt: 25 N·m (2.5 kgf-m, 18.4 ft-lb) Brake hose bracket: 33 N·m (3.4 kgf-m, 24.3 ft-lb) 3. Connect the ground terminal to battery sensor. NOTE 4. Using the Subaru Select Monitor, exit the brake maintenance mode according to the display screen. Parking Brake System > OPERATION NOTE: For detailed operation procedures, refer to “Application help”. 5. After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally. 6. Install the rear wheels. Tightening torque: 120 N·m (12.2 kgf-m, 88.5 ft-lb) |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. Air Intake Duct > REMOVAL3. Remove the clip (A), and loosen the clamps (B) and (C).4. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.5. Disconnect the transmission ...