1. Insert the ST into the clutch disc and insert the ST end into the pilot bearing. NOTE: When installing the clutch disc, be careful to attach in the correct direction.
2. Install the clutch cover and tighten the bolts to specified torque. NOTE: • When installing a clutch cover, position the clutch cover so that the spacing between the unbalance marks (paint mark) on the flywheel and clutch cover is 120° or more apart. (The unbalance mark indicates the direction of residual unbalance.) • Temporarily tighten the bolts by hand. Each bolt should be tightened to the specified torque in a crisscross order. Tightening torque: 16 N·m (1.6 kgf-m, 11.8 ft-lb)
3. Remove the ST.
4. Install the transmission assembly. Manual Transmission Assembly > INSTALLATION |
Alarm system
The alarm system helps to protect your
vehicle and valuables from theft. The horn
sounds and the hazard warning flashers
flash if someone attempts to break into
your vehicle.
For models with "keyless access with
push-button start system":
The system can be armed or disarmed
with the keyles ...