1. Install the clutch pipe to the mass damper, clutch damper, master cylinder and pipe grommet. NOTE: Temporarily tighten the clutch pipe (D) to the clutch damper. Tightening torque: T: 15 N·m (1.5 kgf-m, 11.1 ft-lb)
2. Install the pedal assembly. Clutch Pedal > INSTALLATION 3. Install the tank hose to the clutch pipe. CAUTION: Be sure to install the tank hose with the marking side facing upward. 4. Engage the clutch pipe with the connector attached to the clutch bracket. Tightening torque: T1: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 5. Tighten the clutch pipe. Tightening torque: 15 N·m (1.5 kgf-m, 11.1 ft-lb) 6. Install the steering column. Steering Column > INSTALLATION 7. Install the clutch hose to the operating cylinder. CAUTION: Be sure to install the clutch hose with the marking side facing upward. NOTE: Use a new gasket. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 8. Install the clutch hose to the clutch hose bracket, and install the clamp. CAUTION: • Be sure to install the clutch hose with the marking side facing upward. • Install the clutch hoses while making sure that there is no twisting.
9. Install the clutch pipe to the clutch hose and connector. Tightening torque: T: 15 N·m (1.5 kgf-m, 11.1 ft-lb)
10. Fill the recommended brake fluid. Clutch Fluid 11. Bleed air from the clutch system, and ensure that no fluid leaks. Clutch Fluid Air Bleeding > PROCEDURE 12. Install the instrument panel lower cover. Instrument Panel Lower Cover > INSTALLATION 13. Install the air intake boot. Air Intake Boot > INSTALLATION 14. Connect the ground terminal to battery sensor. NOTE |
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the air intake duct. Air Intake Duct > REMOVAL3. Remove the clip (A), and loosen the clamps (B) and (C).4. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.5. Disconnect the transmission ...