1. CLUTCH SWITCH 1. Install the clutch switch. 2. Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and measure the clutch pedal stroke. Clutch pedal full stroke A: 130 — 135 mm (5.12 — 5.31 in) Tightening torque: T: 8 N·m (0.8 kgf-m, 5.9 ft-lb) 3. If the clutch pedal stroke is out of specification, adjust the stroke. Clutch Pedal > ADJUSTMENT 4. Connect the connector to the clutch switch. 5. Thereafter, install in the reverse order of removal. 2. CLUTCH START SWITCH 1. Install the clutch start switch. 2. Fully depress the clutch pedal and hold it. 3. Install so that gap (A) of the clutch pedal plate and clutch start switch is 2.9 mm (0.11 in), and tighten the lock nut. Tightening torque: 8 N·m (0.8 kgf-m, 5.9 ft-lb)
4. Connect the connector to the clutch start switch. 5. Make sure that engine does not start with clutch pedal not depressed. 6. Make sure that engine starts with clutch pedal fully depressed. 7. Thereafter, install in the reverse order of removal. |
Adjustment
1. VDC SENSOR MIDPOINT SETTING MODEAfter installing, replacing or adjusting the following parts, perform the VDC sensor midpoint setting mode.• Steering angle sensor• Steering wheel• Suspension parts• Wheel alignment• VDCCM&H/U• VDCCM&H/U bracket1. Park the vehicl ...