1. Install the master cylinder to the pedal assembly. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
2. Install the clutch pipe to the master cylinder. Tightening torque: 15 N·m (1.5 kgf-m, 11.1 ft-lb) 3. Connect the clutch stroke sensor connector. 4. Install the push rod of the master cylinder, and install the clevis pin and clip. CAUTION: Always use a new clevis pin. NOTE: Apply grease to the clevis pin.
5. Install the pedal assembly. Clutch Pedal > INSTALLATION 6. Install the steering column. Steering Column > INSTALLATION 7. Fill the recommended brake fluid. Clutch Fluid 8. After bleeding air from the clutch system, ensure that no fluid leaks and the clutch operates properly. Clutch Fluid Air Bleeding 9. Install the instrument panel lower cover. Instrument Panel Lower Cover > INSTALLATION 10. Connect the ground terminal to battery sensor. NOTE |
Arming the system
NOTE
The system can be armed even if the
engine hood, the windows and/or
moonroof are open. Always make sure
that they are fully closed before arming
the system.
When arming the system, if any of
the doors or the rear gate/trunk lid is
not fully closed, an electronic ch ...