NOTE: • Use a new gasket. • Be sure to install the clutch hose with the mark side facing upward. • Be careful not to twist the clutch hose during installation. • Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinder. Grease NICHIMOLY N-130 or equivalent 1. Install the operating cylinder to the transmission, and connect the clutch hose to the operating cylinder. Tightening torque: T1: 18 N·m (1.8 kgf-m, 13.3 ft-lb) T2: 37 N·m (3.8 kgf-m, 27.3 ft-lb)
2. After bleeding air from the operating cylinder, ensure that the clutch operates properly. Clutch Fluid Air Bleeding > PROCEDURE 3. Install the air intake boot. Air Intake Boot > INSTALLATION 4. Connect the ground terminal to battery sensor. NOTE |
Installation
CAUTION:After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.1. Install the GPS antenna assembly.2. Install the audio assembly or navigation assembly.3. Install the heater control assembly.4. Install th ...