NOTE: Apply the specified grease to lubricate to the following points before installation. • Contact surface of lever and pivot • Contact surface of lever and bearing • Transmission main shaft spline • Contact surface of release bearing and transmission case Grease NICHIMOLY N-130 or equivalent 1. While pushing the release lever to the pivot and twisting it to both sides, fit the lever spring onto the raised portion of the pivot. NOTE: Observing from the main case hole, check that the lever spring is installed securely. 2. Install the release bearing and fasten it with two clips. 3. Install the dust cover.
4. Operate the release lever and check if the release bearing moves smoothly. 5. Apply grease to the contact point of the release lever and operating cylinder. Grease NICHIMOLY N-130 or equivalent 6. Install the transmission assembly. Manual Transmission Assembly > INSTALLATION |
If you have accidentally triggered the alarm
system
To stop the alarm
Perform any of the following operations.
Press any button on the access key/
remote transmitter.
Turn the ignition switch to the "ON"
position (models without "keyless access
with push-button start system").
Turn the push-button ignition switch to
...