Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the CVTF cooler (with warmer feature). Tightening torque: 23 N·m (2.3 kgf-m, 17.0 ft-lb)
2. Install the engine coolant inlet hose. NOTE: With the paint on the engine coolant inlet hose facing the vehicle outside, install the hose to the engine side pipe.
3. Install the CVTF inlet hose and CVTF outlet hose. NOTE: Use the new CVTF inlet hose and CVTF outlet hose. • Without CVTF cooler (air cool)
• With CVTF cooler (air cool)
4. Connect the engine coolant outlet hose. • Without CVTF cooler (air cool)
• With CVTF cooler (air cool)
5. Check installation condition of each hose. • Make sure the hoses do not interfere with each other or with other components. • Check each hose for bent, excess curve, and twisting conditions. • Without CVTF cooler (air cool)
• With CVTF cooler (air cool)
6. Install the harness clip.
7. Install the air intake boot assembly. Air Intake Boot > INSTALLATION 8. Connect the ground terminal to battery sensor. NOTE 9. Fill engine coolant. Engine Coolant > REPLACEMENT 10. Adjust the CVTF level. CVTF > ADJUSTMENT |
Assembly
1. Install the harness stay.Tightening torque:23 N·m (2.3 kgf-m, 17.0 ft-lb)2. Install the CVTF cooler (with warmer feature).Tightening torque:23 N·m (2.3 kgf-m, 17.0 ft-lb) ...
Inspection
Replace any faulty CVTF cooler hoses, CVTF cooler pipes and clamps found in the inspection below.1. Check that there are no CVTF or engine coolant leaks from the connections.2. Check the clamp for def ...
Other materials:
Dtc u0426 invalid data received from immobilizer control module
DTC DETECTING CONDITION:Invalid data was transmitted from immobilizer CM.TROUBLE SYMPTOM:Immobilizer does not operate normally.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with Diagnostic Trouble Code ( ...
