1. Install the inhibitor switch to the transmission case temporarily. 2. Connect the inhibitor harness connector. 3. Install the shifter arm and fix with the spring pin. NOTE: Use new spring pin.
4. Shift the shifter arm to “N” range. 5. Install the ST vertically in the cutout of shifter arm and the hole of switch body.
6. Tighten the two bolts holding the inhibitor switch. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 7. Install the select cable to the shifter arm. 8. Install the washer and snap pin.
9. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION 10. Lower the vehicle. 11. Connect the ground terminal to battery sensor. NOTE 12. Check the inhibitor switch. Inhibitor Switch > INSPECTION |
Recommended tire inflation pressure
Recommended cold tire inflation
pressure
For the recommended cold tire
inflation pressure for your vehicle's
tires, refer to "Tires" F12-9.
Vehicle placard
The vehicle placard is affixed to the
driver's side B-pillar.
Example:
The vehicle placard shows original
tire size, recommended ...