Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr580) / Primary speed sensor / Installation

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.

1. Connect the harness connector.

2. Install the primary speed sensor.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

3. Install the transmission assembly. Automatic Transmission Assembly > INSTALLATION

Inspection

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot from the throttle body, and move it to the left side ...

Reduction drive gear

...

Other materials:

Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Lift up the vehicle.3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL4. Remove the center exhaust cover.5. Remove the clamp cable and take out the MT gear shift cable from the clamp.(A)Clamp cable6. Remove the dust cover. ...