CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part. • After installing the secondary pressure sensor, adjust the CVTF level. 1. Install the secondary pressure sensor. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) 2. Connect the harness connector. 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE 5. Refill CVTF to adjust the CVTF level. CVTF |
Dtc u0100 lost communication with ecm/pcm "a"
DTC DETECTING CONDITION:No data is received from ECM.TROUBLE SYMPTOM:Cooperation control of transmission may not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with Diagnostic Trouble Cod ...