Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part. • After installing the secondary speed sensor, adjust the CVTF level. 1. Install the secondary speed sensor. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 2. Connect the harness connector. 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE 5. Refill CVTF to adjust the CVTF level. CVTF |
Inspection
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot, and move it to the left side wheel apron.4. Disconn ...
Other materials:
Inspection
1. Visually check the ambient sensor for dirt or damage, and clean or replace as necessary.2. Measure the resistance between ambient sensor terminals.CAUTION:During inspection, be careful not to touch the sensor end in order to avoid misjudgment due to body temperature.Preparation tool:Circuit teste ...
