1. Install the O-ring to the input shaft. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. 2. While holding the torque converter assembly by hand, carefully install it into the torque converter case. NOTE: • Apply CVTF to the oil seal lip. • Do not damage the oil seal and O-ring. 3. Engage the splines while gently rotating the torque converter assembly by hand, and securely insert the assembly. 4. Measure depth “A”, from converter case end surface to drive plate contacting surface. Standard (reference): 6.8 mm (0.268 in) or less 5. Install the transmission assembly. Automatic Transmission Assembly > INSTALLATION |
Disassembly
1. Remove the bearing retainer using ST1, ST2 and ST3.ST1 899864100REMOVERST2 398497701SEATST3 18767AA000BEARING REMOVER2. Remove the snap ring.3. Remove the ball bearing using ST1, ST2 and ST3.ST1 899864100REMOVERST2 398497701SEATST3 498077600REMOVER ...