1. Install the TCM. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 2. Install the harness connector to TCM. NOTE: Move the lock lever in the arrow direction, and confirm that a clicking sound is heard. 3. Insert the transmission case cover (small) between transmission case cover (large) and transmission to install. NOTE: When inserting, be careful that the insulator inside transmission case cover is not turned over. Tightening torque: 7 N·m (0.7 kgf-m, 5.2 ft-lb) 4. Install the harness clip, and connect the following transmission radio ground terminal and transmission harness connector. Tightening torque: 13 N·m (1.3 kgf-m, 9.6 ft-lb)
5. Install the air intake boot assembly. Air Intake Boot > INSTALLATION 6. Connect the ground terminal to battery sensor. NOTE 7. Perform the operation of AT learning mode. Learning Control |
Activating and deactivating the alarm system
To change the setting of your vehicle's
alarm system for activation or deactivation,
do the following.
Disarm the alarm system. Refer to
"Disarming the system" .
Sit in the driver's seat and shut all
doors (and the rear gate (Outback)).
Turn the ignition switch to the ...