Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

1. Clean the mating surface of the extension case and intermediate case.

2. Select the thrust needle bearing. Rear Drive Shaft > ADJUSTMENT

3. Select the shim for transfer reduction driven gear. Transfer Reduction Driven Gear > ADJUSTMENT

4. Install the selected thrust needle bearing to transfer clutch assembly.

NOTE:

Install the thrust needle bearing in the correct direction.

5. Attach the selected shim to transfer reduction driven gear assembly.

6. Apply liquid gasket to extension case seamlessly.

Liquid gasket:

THREE BOND 1215B or equivalent

7. Install the extension case.

Tightening torque:

25 N·m (2.5 kgf-m, 18.4 ft-lb)

8. Install the front wheel speed sensor. Front Wheel Speed Sensor > INSTALLATION

9. Install the transmission assembly. Automatic Transmission Assembly > INSTALLATION

Adjustment
NOTE:When replacing the extension case, select the shims for rear drive shaft thrust needle bearing and transfer reduction driven gear. Rear Drive Shaft > ADJUSTMENT Transfer Reduction Driven Gear > ...

Inspection
• Check there is no leak of CVTF from the joint between extension case and intermediate case.• Check there is no damage or cracks on the extension case. ...

Other materials:

Adjustment
1. Measure clearance “A” between snap ring and transmission case.Specification:0.05 — 0.25 mm (0.002 — 0.01 in)2. If clearance “A” is out of standard, select the snap ring within standard.Snap ringPart No.Thickness mm (in)8051004602.0 (0.079)8051004612.1 (0.083)8051004622 ...

© 2017-2024 Copyright www.sulegacy.com