CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of front wheel speed sensor. If adhesion occurs, replace with a new part. • After installing the front wheel speed sensor, adjust the CVTF level. 1. Install the front wheel speed sensor. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 2. Connect the harness connector. 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE |
Installation
CAUTION:• When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT• Before ...