1. Install the inhibitor switch to the transmission case temporarily. 2. Connect the inhibitor harness connector to the inhibitor switch. 3. Install the shifter arm and fix with the spring pin. NOTE: Use new spring pin.
4. Shift the shifter arm to “N” range. 5. Install the ST vertically in the cutout of shifter arm and the hole of switch body.
6. Tighten the two bolts holding the inhibitor switch. Tightening torque: 5 N·m (0.5 kgf-m, 3.7 ft-lb) 7. Install the select cable to the shifter arm. 8. Install the washer and snap pin to the shifter arm.
9. Install the harness stay. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 10. Install the front exhaust pipe. Front Exhaust Pipe > INSTALLATION 11. Lower the vehicle. 12. Connect the ground terminal to battery sensor. NOTE 13. Check the inhibitor switch. Inhibitor Switch > INSPECTION |
Dtc p0463 fuel level sensor "a" circuit high
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.STEPCHECKYESNO1.CHECK FOR ANY OTHER DTC ON DISPLAY.Is DT ...