1. Clean the mating surface of intermediate case and transmission case. 2. Face the O-ring side of the CVTF filter to the intermediate case side, and install the CVTF filter. NOTE: Apply CVTF to the O-rings. 3. Install the O-ring to the transmission case. NOTE: • Use new O-rings. • Apply CVTF to the O-rings. 4. Apply liquid gasket to intermediate case seamlessly. Liquid gasket: THREE BOND 1215B or equivalent 5. Install the intermediate case and the transmission hanger to the transmission case. NOTE: Make sure to install the arrowed bolt. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 6. Install the transfer reduction driven gear assembly. Transfer Reduction Driven Gear > INSTALLATION 7. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION 8. Install the rear drive shaft. Rear Drive Shaft > INSTALLATION 9. Install the parking pawl. Parking Pawl > INSTALLATION 10. Install the extension case. Extension Case > INSTALLATION 11. Install the transmission to vehicle. Automatic Transmission Assembly > INSTALLATION |
Dtc b1795 occupant detection module internal circuit
DTC DETECTING CONDITION:When the following DTCs are detected:B1763, B1764, B1765, B1766, B1767, B1768, B1769, B176A, B176B, B176C, B176D, B176E, B176F, B1770, B1772, B1776, B1777, B1778NOTE:DTC B1795 is detected at the same time when any of the DTCs above is detected. When the detected DTC is elimin ...