CAUTION: • Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part. • After installing the secondary pressure sensor, adjust the CVTF level. 1. Install the secondary pressure sensor. NOTE: • Use new O-rings. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) 2. Connect the harness connector. 3. Lower the vehicle. 4. Connect the ground terminal to battery sensor. NOTE Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) |
Removal
1. RADIO ANTENNA AMPLIFIER• Sedan model1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - rear pillar UPR LH. Rear Quarter Trim > REMOVAL3. Remove the amplifier assembly - antenna.(1) Disconnect the ...