Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Secondary speed sensor / Installation

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.

1. Install the secondary speed sensor.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

Tightening torque:

5 N·m (0.5 kgf-m, 3.7 ft-lb)

2. Connect the harness connector.

3. Install the transmission cover.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

4. Install the transmission assembly. Automatic Transmission Assembly > INSTALLATION

Inspection

1. Remove the bulkhead harness connector from TCM. Transmission Control Module (TCM) > REMOVAL2. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD3. Set the probe of oscillo ...

Torque converter assembly

...

Other materials:

Removal
CAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.1. Disconnect the ground terminal from battery sensor. NOTE2. Disconnect the connector (A) from the oil pressure switch, and remove the oil pressure switch fr ...