Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Transmission control device / Installation

1. Install the detent spring to the transmission case.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

2. Install the manual plate, parking rod, range select lever and bolt.

Tightening torque:

7 N·m (0.7 kgf-m, 5.2 ft-lb)

(A)	Bolt
(B)	Range select lever
(C)	Manual plate
(D)	Parking rod

3. Install the spring pin.

NOTE:

Use new spring pin.

4. Install the inhibitor switch. Inhibitor Switch

5. Adjust the inhibitor switch. Inhibitor Switch

6. Install the control valve body and oil pan. Control Valve Body > INSTALLATION

7. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION

Inspection

Make sure that the manual lever and detent spring are not worn or otherwise damaged. ...

Transmission control module (tcm)

...

Other materials:

Dtc b1795 occupant detection module internal circuit
DTC DETECTING CONDITION:When the following DTCs are detected:B1763, B1764, B1765, B1766, B1767, B1768, B1769, B176A, B176B, B176C, B176D, B176E, B176F, B1770, B1772, B1776, B1777, B1778NOTE:DTC B1795 is detected at the same time when any of the DTCs above is detected. When the detected DTC is elimin ...