1. When replacing the new MT gear shift cable, secure it to shift bracket with the clamps, be careful not to mistake the installing direction.
2. Install the shift bracket together with the MT gear shift cable. CAUTION: • Do not bend MT gear shift cable at a sharp angle. • Do not twist the cable inner excessively. NOTE: When installing the MT gear shift cable, make sure that the mark or blue mark on the cable faces up.
3. Tighten the shift bracket with specified torque. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
4. Install the snap pin.
5. Install the dust cover. (OUTBACK model) Tightening torque: 15 N·m (1.5 kgf-m, 11.1 ft-lb) 6. Insert the MT gear shift cable into the cover cable assembly, and secure it with the clamp.
7. Connect the MT gear shift cable. 8. Install the plate cable assembly. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 9. Insert the MT gear shift cable into clamp cable, and install to the transmission. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb)
10. Install the center exhaust cover. Tightening torque: 18 N·m (1.8 kgf-m, 13.3 ft-lb) 11. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION 12. Lower the vehicle. 13. Connect the ground terminal to battery sensor. NOTE 14. Make sure the gears can be shifted accurately into each gear. |
Caution
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.• When replacing the parts provided with memory functions such as audio, record the memory contents before disconnecting the battery ground cable.• Be careful of the following ...