Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the ambient sensor. 2. Install the active grille shutter using the bolts securing the active grille shutter. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 3. Connect the connector to the active grille shutter actuator. 4. Connect the connector to the ambient sensor. 5. Install the front bumper. Front Bumper > INSTALLATION 6. Connect the ground terminal to battery sensor. NOTE 7. When the active grille shutter has been replaced, perform the calibration (execute the system operation check for ACTGS control). Active Test > OPERATION |
Inspection
Check that the active grille shutter does not have deformation, cracks and any other damage. ...
Engine coolant
...
Other materials:
Inspection
1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsStandardCircuit1 — 2Always1 M- or mor ...
