Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Cooling(h4do) / Radiator fan and fan motor assembly / Installation

1. Position the radiator fan & fan motor assembly, and install the radiator fan & fan motor assembly to the claw on the radiator upper side.

2. Connect the connector to the radiator main fan motor, as well as the connector to the radiator sub fan motor.

3. Install the reservoir tank. Reservoir Tank > INSTALLATION

4. Connect the radiator inlet hose to the radiator.

5. Install the air intake duct. Air Intake Duct > INSTALLATION

6. Lift up the vehicle.

7. Install the under cover. Front Under Cover > INSTALLATION

8. Lower the vehicle.

9. Connect the ground terminal to battery sensor. NOTE

10. Fill engine coolant. Engine Coolant > REPLACEMENT

Assembly

1. RADIATOR MAIN FAN AND RADIATOR MAIN FAN MOTOR1. Install the radiator main fan motor to the radiator fan shroud.Tightening torque:3.9 N·m (0.4 kgf-m, 2.9 ft-lb)2. Install the radiator main fa ...

Inspection

Check that the radiator fan, radiator fan shroud and fan motor do not have deformation, cracks or damage. ...

Other materials:

Dtc p2096 post catalyst fuel trim system too lean bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...