CAUTION: • Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION • Do not allow harness and connectors to interfere or get tangled up with other parts. • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position. • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT • Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation. 1. Install the cruise control command switch assembly. 2. Align the center position of the steering roll connector. Roll Connector > ADJUSTMENT 3. Install the steering wheel. Tightening torque: 39 N·m (4.0 kgf-m, 28.8 ft-lb) Clearance: Between cover assembly - column and steering wheel: 4 — 6 mm (0.16 — 0.24 in) 4. Install the driver’s airbag module. Driver’s Airbag Module > INSTALLATION 5. Connect the ground terminal to battery sensor. NOTE |
Dtc u0074 control module communication bus "body-can" off
DTC DETECTING CONDITION:Integrated unit communication is shut down because of high speed CAN error.TROUBLE SYMPTOM:CAN communication is not normal.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnostic procedure performed up to STEP 8- Diagnostic Procedure with Diagn ...