Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. Install the socket assembly. NOTE: Align the groove of the pocket assembly - CTR with the claw of the socket assembly. 2. Install the pocket assembly - CTR. 3. Install the panel center LWR. 4. Install the cover assembly - front and the console box assembly. Tightening torque: 6.5 N·m (0.6 kgf-m, 4.8 ft-lb) 5. Install the heater control assembly. 6. Connect the ground terminal to battery sensor. NOTE |
Wiring diagram
Refer to “Front Accessory Power Supply Socket System” in the wiring diagram. Front Accessory Power Supply Socket System > WIRING DIAGRAM ...
Removal
1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the heater control assembly. Control Panel > REMOVAL3. Remove the cove ...
Other materials:
Electrical component location location
(1)VDC control module and hydraulic control unit (VDCCM&H/U)(6)Brake light relay(10)Hill hold switch(2)VDC OFF switch(7)Magnetic encoder(11)Engine control module (ECM)(3)Combination meter(8)ABS wheel speed sensor(12)Transmission control module (TCM) (engine type FB)(4)Steering angle sensor(9)Parking ...
