1. Temporarily fit the hinge COMPL - front hood around the original position on the vehicle body. 2. Install the hood COMPL - front to the hinge COMPL - front hood. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 3. Install the stay assembly - front hood. 4. When temporarily fitting the fender COMPL - front and adjusting the clearance, make sure that a uniform clearance is created around the hood COMPL - front. NOTE: When installing the fender COMPL - front, make sure that a uniform clearance is created around it. • Fender COMPL - front to Hood COMPL - front: Front Hood > ADJUSTMENT • Fender COMPL - front to Panel assembly - front door: Front Door > ADJUSTMENT 5. Install the hinge COMPL - front hood. (1) Tighten the bolts at the front side, and temporarily fit the bolts at the rear side. (2) Remove the fender COMPL - front. (3) Tighten the hinge COMPL - front hood to the specified torque. Tightening torque: 25 N·m (2.5 kgf-m, 18.4 ft-lb) 6. Readjust the fender COMPL - front to install. NOTE: When installing the fender COMPL - front, make sure that a uniform clearance is created around it. • Fender COMPL - front to Hood COMPL - front: Front Hood > ADJUSTMENT • Fender COMPL - front to Panel assembly - front door: Front Door > ADJUSTMENT |
Transmission
1. MTModel2.5 L DOHC non-turboTransmission type6MTClutch typeDSPDGear ratio1st3.5452nd1.8883rd1.2964th1.0295th0.8256th0.738Rev.3.636Reduction gear (front)Type of gearHypoidGear ratio4.111Transfer reductionType of gearHelicalGear ratio1.000Reduction gear (rear)Final reductionType of gearHypoidGear ra ...